Collectors Edition Saber - 89 Sabers DV6 Darth Vader Episode VI
89 Sabers DV6
A Darth Vader saber inspired by Return of the Jedi, this hilt has been installed by Jimmy from Jimmy's Saber Junk himself using his crystal reveal chassis, the crystal is wired to mimic blade colour and uses a recharge port and kill key, this saber comes with all the parts to set up in either New Hope or Empire Strikes Back configuration.
https://www.instagram.com/jimmys_saber_junk/
This saber does not come with a blade and is not designed for duelling
Comes with grip guide, grips and blade plug, switches, wire pieces, chassis colour may differ
We can add a Nexus neopixel blade for an extra £50
Specifications:
- Hilt: 89 Sabers MPP
-
Chassis: 3D Printed with crystal chamber
- Installed By: Jimmys Saber Junk
- Control Board: Proffieboard v.2.2.
-
Switch Programming: SA-22C two-switch setup
-
Blade Fitting: 1 Inch Neopixel (Not Included)
-
Blade Programming: 132 pixels, Data Pad 1
- Neopixel Connector: Shtok 7 Pin
- Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
- Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
- LED Time Out Delay: 15 minutes
- LED Wiring Layout: LED Pad 2/3, Data 1, Main Blade - LED Pad 5, Data 2, Crystal, sub-blades
All parts and components bought from The Saber Armory