Collectors Edition - 89 Sabers Obi Wan Kenobi - Episode lll

89 SABERS OBI WAN KENOBI
A Obi Wan Kenobi inspired saber from Revenge of the Sith, this is a screen accurate prop replica, this hilt has been installed by Ryan at BlackStar Sabers using a Goth-3D chassis - https://www.instagram.com/blackstarsabers/

Saber comes with Ltd Edition 'Saberist' Magazine designed by Chris Carter from Sabersence specifically made for this Saber

36" Neopixel Blade included

https://sabersense.square.site/


Specifications:
Hilt: 89 Sabers Ben Kenobi Episode III
Chassis: Goth-3D
Installed By: BlackStar Sabers
Control Board: Proffieboard v.2.2.
Operating System: ProffieOS 7.13.
Switch Programming: SA-22C two-switch setup
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 5 minutes
LED Wiring Layout: LED Pad 2/3, Data 1, Main Blade

Hilt Length - 28.5 cm
Blade Diameter - 1"
2.1mm Recharge Point
Includes charger, screws and hex key

Sound Fonts:

Feautres 30 Sound fonts, including fonts by Kyberphonic
https://www.kyberphonicfonts.com/

All parts and components bought from The Saber Armory

https://thesaberarmory.com/